VIEWPOINT RUNNING BOARDS
2011-12 TOYOTA SIENNA
Page 1 of 6 9/20/12 (DP)
PARTS LIST:
Driver/Left side Running Board
Passenger/Right side Running Board
10mm Bent Threaded Rod Bolts
Driver/Left front Mounting Bracket
Passenger/Right front Mounting Bracket
10-1.5mm x 25mm Hex Bolts
Driver/Left front Support Bracket
10mm x 27mm x 3mm STD Flat Washers
Passenger/right front Support Bracket
10mm x 34mm x 3mm Large Flat Washers
Driver/left center Mounting Bracket
10mm Serrated Flange Nuts
Passenger/right center Mounting Bracket
Driver/Left rear Mounting Bracket
6mm x 22mm OD x 2mm Flat Washers
Passenger/right rear Mounting Bracket
10mm x 35mm button head Bolt Plates
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. CUTTING IS REQUIRED. ASSISTANCE IS
RECOMMENDED.
2. Start installation under the driver side front of the vehicle. Remove the plastic cover, (Fig. 1). Pay close
attention to the type and location of all factory hardware for reinstallation.
3. Locate the (2) factory holes in the inside wall of the floor panel, (Fig. 2). NOTE: The mounting locations
may be covered by sealant or undercoating. Use a small screwdriver to poke through the sealant to
uncover the hole. IMPORTANT: Brackets must sit flat against sheet metal. Scrape any excess sealant
from body panel before installing any and all Brackets.
Driver/Left Rear
Mounting Bracket
Driver/Left Front
Mounting Bracket
Driver/Left
Center Bracket
Passenger/Right
Rear Mounting
Bracket
Passenger/Right
Center Bracket
Passenger/Right Front
Mounting Bracket
(2) 10mm x 50mm T-Bolts
(For Rear Brackets only)
(2) 10mm x 35mm
Button Head Bolt Plates
Driver/Left
Running Board
Passenger/Right
Running Board
Driver/Left Front
Support Bracket
Passenger/Right Front
Support Bracket
Commenti su questo manuale